Search for answers or browse our knowledge base.
F1 – Shorted sensor or shorted sensor wire harness.
F2 – Open sensor or sensor wire harness unplugged.
F1 or F2 in both displays at the same time usually would mean that the control itself is defective as it would be unlikely that both sensors would develop a problem at the same time. The board will need to be repaired or replaced.
F3 – Potential Grounding Problem. Try powering down the machine and then back up, then push the programming button to start the dryer. You may also need to reset the machine with the PalmPilot. If these do not work, try removing and reinstalling the battery.
F4 – There is a problem with your control board board, it will need to be repaired or replaced.
F5 – Microchip electrical problem. Try powering off for one minute then back on. Also try removing and reinstalling the batter on the control board. If this does not work, the board will need to be repaired or replaced.