Cycle Time in Seconds (CyCS)

This option lets you set the cycle time is seconds. It is only available if you have software version S003 or higher. The total cycle time will be the sum of cycle minutes expressed in seconds. 

1. Enter Manual Mode: Follow the steps in the “Entering Manual Mode” section. 
2. Access programming: Press LOW TEMP (∧) or DELICATES (∨) until “PrOg” appears in the Four-Digit Display, then press START (enter). “AtS” will appear. 
3. Press LOW TEMP (∧) or DELICATES (∨) to find “CyCS,” then press START (enter). 
4. Adjust cycle time (seconds): The current number of seconds set for the cycle time will appear in the display. 
5. Use LOW TEMP (∧) or DELICATES (∨) to increase or decrease the number of seconds to the desired value. 
   1. Note: The cycle time (seconds) can be set from 0 to 59 seconds. The default value is 0 seconds. 
   2. Important: The total cycle time (minutes + seconds) cannot exceed 99 minutes. 
6. Save changes: Press START (enter) when the correct number of seconds is displayed. “Cd” (Cool Down Time) will appear next. 
7. To exit programming: Ensure an option is displayed (not a value). Press and hold HIGH TEMP and MED TEMP simultaneously. The control will return to its previous mode.