Cycle Time in Minutes (CyCL)

This lets you set the amount of time for any cycle in minutes. 

1. Enter Manual Mode: Follow the steps in the “Entering Manual Mode” section. 
2. Access programming: Press LOW TEMP (∧) or DELICATES (∨) until “PrOg” appears in the Four-Digit Display, then press START (enter). “AtS” will appear. 
3. Press LOW TEMP (∧) or DELICATES (∨) to find “CyCL,” then press START (enter). 
4. Adjust cycle time: The current number of minutes set for the cycle time will appear in the display. 
5. Use LOW TEMP (∧) or DELICATES (∨) to increase or decrease the number of minutes to the desired value. 
   1. Note: The cycle time can be set from 1 to 99 minutes. The default value is 10 minutes. 
6. Save changes: Press START (enter) when the correct number of minutes is displayed. 
   1. If seconds are enabled, “CyCS” (Cycle Time [Seconds]) will appear next. (this option is only available on software version S003 or higher. 
   2. If seconds are not enabled, “Cd” (Cool Down Time) will appear next. 
7. To exit programming: Ensure an option is displayed (not a value). Press and hold HIGH TEMP and MED TEMP simultaneously. The control will return to its previous mode.